Discourse/Guilds Laser/2019-01-11 Laser misaligned

📜 Discourse Archive This page is preserved verbatim from discuss.noisebridge.info, the Noisebridge community forum that operated roughly 2018–2022. The original site is defunct; this content was recovered via the Wayback Machine and is archived here as a primary source for Noisebridge history. ⮡ Original URL: https://discuss.noisebridge.info/t/laser-misaligned/106 📦 Verify on Wayback Machine 📅 Archived: 2021-01-21 🏷 Original category: Guilds_Laser

Laser misaligned

---

mcscope

Hey there,

The laser alignment is not perfect right now. While the trainers are going to fix it, in the mean time I recommend cutting in the upper left corner of the bed where the laser is strongest.

The red laser is not the one that cuts, it’s just a tracer laser. It’s not aligned perfectly either right now. Don’t pay attention to it

---

_ar _2019-01-11_

One note about the back left corner: there’s a bump in the honeycomb there that can make it hard to get your material to be the same height over the area of the cut. Particularly if you have a larger cut, it may help to be aware of / avoid it. I find it a little hard to see from the front sometimes, but it becomes quite apparent if one runs their hand over that corner.

---

---

mcscope — 2019-02-02

I believe these issues have been fixed by now! Thanks to talented Laser Guild members and laser trainers!

---